I found this nifty little vise over on the Prints and Plans Yahoo group, posted by "SterTrak". The design allows for the vise to be as large as the length of your mill's table – which makes it great for holding larger parts.

But as you can see from the pictures, it works just as well for smaller items.

If you decide to make your own please take a few pictures of the process and post them to the forum!

  Versatile_Mill_Vise_Plans.pdf (844.6 KiB, 330 hits)
NOTE: You need to be a registered member (and logged in) to download this file. You can register or log in using the "Log In" section located in the upper left corner of the site (don't worry, it's free to register and your email address will be kept private). Please note, subscribing to the RSS feed is not the same as registering. Also, registering for the site will grant you forum access, allowing you to log into the forum using the same username and password you used to register for the site.

Read the original blog post