Free Metalworking Project Plans: A Small, Low Profile Vise for the Mill
Material: Steel
Units (mm)
Here’s a nice set of plans by Clark P. for a small 5cm vise for your mill. Clark wrote a great instructable on the project that I’ve linked to below. You can view instructable via the embedded player, or you can download a PDF copy of the step-by-step plans (at the very bottom of the post below the flash player).
You can also download a copy of the PDF plans directly from the instructables website, but you need to be a member to do that, so I’m saving you that step by linking to them here.
A small low profile machine vise – More DIY How To Projects
A-small-low-profile-machine-vise.pdf (489.1 KiB, 2,314 hits)
NOTE: You need to be a registered member (and logged in) to download this file. You can register or log in using the "Log In" section located in the upper left corner of the site (don't worry, it's free to register and your email address will be kept private). Please note, subscribing to the RSS feed is not the same as registering. Also, registering for the site will grant you forum access, allowing you to log into the forum using the same username and password you used to register for the site.
Small_Vise_Drawings.pdf (187.1 KiB, 1,937 hits)
NOTE: You need to be a registered member (and logged in) to download this file. You can register or log in using the "Log In" section located in the upper left corner of the site (don't worry, it's free to register and your email address will be kept private). Please note, subscribing to the RSS feed is not the same as registering. Also, registering for the site will grant you forum access, allowing you to log into the forum using the same username and password you used to register for the site.
To leave a comment join the forum discussion on this post
Tags: Intermediate, Mill, Units (mm)
