Free Metalworking Project Plans: No. 2 Tube & Pipe Bender
Material: Steel
Units: (in)
These plans are for for a tube and pipe bender similar to the Hossfeld #2 bender (pictured). It looks like these plans may have been circulating for some time. I found them on Don Kinzers’ website, and Don found them on a website that no longer exists. These plans don’t exactly fall within the Mill or Lathe category, so I’m going to put them in a new Miscellaneous category.
Below you’ll find links to 2 different zip files containing identical plans in 2 different formats. The first is in .jpg format, the second is in .dxf format (only useful if you have AutoCad or similar software installed on your system).
bender.zip (2.1 MiB, 1,632 hits)
NOTE: You need to be a registered member (and logged in) to download this file. You can register or log in using the "Log In" section located in the upper left corner of the site (don't worry, it's free to register and your email address will be kept private). Please note, subscribing to the RSS feed is not the same as registering. Also, registering for the site will grant you forum access, allowing you to log into the forum using the same username and password you used to register for the site.
bend_dxf.zip (242.3 KiB, 664 hits)
NOTE: You need to be a registered member (and logged in) to download this file. You can register or log in using the "Log In" section located in the upper left corner of the site (don't worry, it's free to register and your email address will be kept private). Please note, subscribing to the RSS feed is not the same as registering. Also, registering for the site will grant you forum access, allowing you to log into the forum using the same username and password you used to register for the site.
To leave a comment join the forum discussion on this post - (1) Posts
Tags: Units (in)
